Well it's not actually woven, but it has the same look in the end. First I took seven 1" wide strips. They could be any width, but the wider the strip, the bigger the finished star will be. I thought if I chose 1" it would be on the small side, not really knowing exactly what I was getting into, but it turns out it's a kind of big -- close to 24" completed. I didn't measure the lengths, just eyeballed it! I'll cover how I lucked out on the length a little bit down the post, and how to be precise if you're inclined to be, which I usually am, but this time I didn't really know how long they'd need to be.
Then I sewed them together lengthwise.
I made a total of 7 sets of strips each with seven pieces of the same fabrics, alternating the order of the strips in each set (from left to right) like this:
set one (the one pictured above): 1-2-3-4-5-6-7
set two: 2-3-4-5-6-7-6
set three: 3-4-5-6-7-6-5
set four: 4-5-6-7-6-5-4
set five: 5-6-7-6-5-4-3
set six: 6-7-6-5-4-3-2
set seven: 7-6-5-4-3-2-1
Next I trimmed the bottom at a 45° angle. I used a 8" square ruler for this because it's got a 45° line running through the middle of it. Again I eyeballed it by lining up the two sides of the strip with vertical lines on my cutting mat. I laid the 45° line of my ruler along the horizontal lines of my cutting mat and perpendicular to the strips, then cut along the angle at the bottom of the ruler:
And I got this:
To cut the pieces of the star sections, I just moved the ruler up the strip by 1" and cut again. My ruler has little white lines running parallel to the edge which I used to get an accurate 1" cut. The width of the cut is determined by the width of the original strips, in my case 1". If I'd cut my original fabric strips 2-1/2" wide, then I'd also cut these pieces 2-1/2" wide. So I lucked out on the length of my strips when I didn't measure -- I had just enough length to cut 8 pieces at this step and that's the number I need from each set of strips to get 8 star points. So this is also how you could determine the length to cut your original strips.
Now when all 8 pieces are cut from the 7 sections of strips, I kept them really well organized so they don't get them mixed up. That would be a big ol' mess since they look almost identical and there's 56 of them. I put them in little piles in the order I mentioned above: a pile of 8 pieces for the first set, a pile of 8 pieces for the second set, a pile of 8 for the third set, etc. I should've taken a picture here, because I know for me a picture makes it easier to grasp, but I didn't. Oh well. So I grab one piece from each of the piles in order of 1-7 and put them together in order so that the colors stagger across the diamond. The picture here shows top piece 1, below that 2, below that 3, etc, to bottom piece 7:
Does that make sense? I hope so. I like you people and I want to be as clear as I can be!
Now I sew the 7 pieces together, turn it on point and here's a diamond! This is the first one of eight sections of the star:
Do it again and put section 2 next to section 1. Then get really excited, because it's looking awesome!
Section 3 done. Yes!!
You're halfway done now!
Section 5 done.
And here I have an almost finished woven star!
I'll finish the last two sets tonight and then figure how to sew inset seams between those points. Do you know how? Do you have a favorite tutorial or method for it? Send it my way!